Will etrailer Scissor Jacks Fit 2014 Premiere Bullet BHS

Question

Question:

Will this Jack work with my 2014 30ft premiere Bullet bhs

asked by: Stacie C

0

Expert Reply:

Yes, the Scissor Jacks part # TJSCHD-24-4 would work on your 2014 Premiere Bullet BHS due to it's universal design.

expert reply by: Jameson C

0

Answer 1

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Answer 2

What tire size do you have now? What is your wheel bolt pattern?

view full answer...

Answer 3

That is a great question. Both of those are great weight distribution hitches. Between the two, I prefer the Reese Dual Cam II over the Strait Line. The Dual Cam uses an L-bracket to attach to the frame, instead of a chain and lift bracket.…

view full answer...

Answer 4

The etrailer Scissor Jacks part #TJSCHD-24-4 would work great on your Keystone Premier Travel Trailer. It has more than enough capacity as it's rated for up to 10k and has a universal mount design that will fit your trailer.

view full answer...

Answer 5

The best place to start for tow bar lighting for your 2023 Jeep Wrangler will be the Roadmaster kit part #RM-15267 which once installed puts a 6-way on the front of the Jeep and then to complete the charge circuit all you would need is the part…

view full answer...

Answer 6

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 9

Hello Gaby. I reached out to the manufacturer and found out that the UltraFab Weld-On Jumbo Steel Roller #UF48-979023 uses a 6-1.0mm Zerk fitting. For a replacement you can use the following: - Replacement Brass Grease Zerk for Weld-On Hinges - 6…

view full answer...

Answer 10

The Scissor Stabilizer Jack #TJSC-24, which also comes in a 2-pack #TJSCHD-24 and a 4-pack #TJSCHD-24-4, is a universal fit so you would need to double check our measurements to ensure they fit your travel trailer. When they are collapsed they…

view full answer...

Will etrailer Scissor Jacks Fit 2014 Premiere Bullet BHS

Product Page this Question was Asked From

Continue Researching