Progressive Dynamics Converter to Charge RV 6 Volt Batteries

Question

Question:

I need toreplace my converter in my 2020 Keystone Bullet Premier. what size converter should I buy? I have two 6V golf cart batteries Ionly want to buy a Progressive dynamics 9200 series of converter. Thanks for any information and advice you can provide.

asked by: James R

0

Expert Reply:

A 60 amp converter like the Progressive Dynamics part # PD9260C would work great on your two 6 volt golf cart batteries wired in series. This will charge them quickly.

expert reply by: Jameson C

0

Answer 1

Yes we can. The correct replacement converter would be the part #PD9270 to replace your WF9865.

view full answer...

Answer 2

The Progressive Dynamics #PD9270 which is typically part of a power center can indeed be used with a solar panel system. The solar panel controller would be wired to the battery which is also wired into the power center/converter as shown in the…

view full answer...

Answer 3

The largest gauge wire that can be ran to the positive and negative terminals of the Progressive Dynamics #PD9270 that you referenced is 2 gauge. You could wire two batteries in parallel from these terminals as well.

view full answer...

Answer 4

I'm assuming 32 is a typo and that you really have two 6v batteries wired together. If you have the batteries wired in parallel the voltage will still be 6v but the amperage of the batteries will be combined. If you wire them in series the…

view full answer...

Answer 5

I reached out to my contact at Progressive Dynamics regarding the Progressive Dynamics #PD92201 Charge Wizard, and was told, "Yes," you can cut the cable and splice in additional length. They advised to use shielded cable and not to exceed…

view full answer...

Answer 6

The Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger #PD9270 your looking at is rated for 70 Amps so while you can technically do this I recommend going with the 60 Amp Version #PD9260C instead because it's a direct…

view full answer...

Answer 7

When you move up to a larger amperage converter you just need to ensure that your wiring is the correct gauge to support the higher amperage. Since you're only going from 40 to 45 amps you're more than likely fine. The next important step is…

view full answer...

Answer 8

A WFCO-8955 is going to have a 55 amp converter so the best replacement option is going to be the Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel #PD4655V, which is an exact replacement for your current converter. Removal…

view full answer...

Answer 9

The Progressive Dynamics converter charger part #PD9260C that you referenced is a 60 amp charger that is compatible with AGM batteries like you have so it would easily work great for you.

view full answer...

Answer 10

You can charge 2 batteries when they are connected in parallel using a battery charger such as #329-GENIUS5. However, it will take longer to charge the batteries when they are connected compared to if you were to charge each one separately. And the…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...