What is Max Wiring Gauge of Progressive Dynamics Converter PD9270

Question

Question:

What is the largest gauge wire do the negative and positive terminals accept? Can the wires be ran in parallel to the batteries as it has two negative and two positive?

asked by: Joseph B

0

Expert Reply:

The largest gauge wire that can be ran to the positive and negative terminals of the Progressive Dynamics # PD9270 that you referenced is 2 gauge. You could wire two batteries in parallel from these terminals as well.

expert reply by: Jameson C

0

Answer 1

Yes we can. The correct replacement converter would be the part #PD9270 to replace your WF9865.

view full answer...

Answer 2

The Progressive Dynamics #PD9270 which is typically part of a power center can indeed be used with a solar panel system. The solar panel controller would be wired to the battery which is also wired into the power center/converter as shown in the…

view full answer...

Answer 3

I reached out to my contact at Progressive Dynamics regarding the Progressive Dynamics #PD92201 Charge Wizard, and was told, "Yes," you can cut the cable and splice in additional length. They advised to use shielded cable and not to exceed…

view full answer...

Answer 4

I'm assuming 32 is a typo and that you really have two 6v batteries wired together. If you have the batteries wired in parallel the voltage will still be 6v but the amperage of the batteries will be combined. If you wire them in series the…

view full answer...

Answer 5

The Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger #PD9270 your looking at is rated for 70 Amps so while you can technically do this I recommend going with the 60 Amp Version #PD9260C instead because it's a direct…

view full answer...

Answer 6

I don't recommend using a higher amp converter as the converter size is based on the load of the trailer and there would be no real benefit of going with an overrated option. That said, if you want to go up 5 amps or so that shouldn't really…

view full answer...

Answer 7

A 60 amp converter like the Progressive Dynamics part #PD9260C would work great on your two 6 volt golf cart batteries wired in series. This will charge them quickly.

view full answer...

Answer 8

When you move up to a larger amperage converter you just need to ensure that your wiring is the correct gauge to support the higher amperage. Since you're only going from 40 to 45 amps you're more than likely fine. The next important step is…

view full answer...

Answer 9

A WFCO-8955 is going to have a 55 amp converter so the best replacement option is going to be the Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel #PD4655V, which is an exact replacement for your current converter. Removal…

view full answer...

Answer 10

The Progressive Dynamics converter charger part #PD9260C that you referenced is a 60 amp charger that is compatible with AGM batteries like you have so it would easily work great for you.

view full answer...

Answer 11

I recommend you start by just replacing the fuses. If that fixes the problem, you are all set. If not, I recommend replacing the power converter with a new unit. I can recommend a similar model to replace your existing converter if you can find the…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

What is Max Wiring Gauge of Progressive Dynamics Converter PD9270

Continue Researching