Dimensions of Base of 2,000 lb 2-Speed Boat Trailer Winch with 20' Strap # 315-W2000D

Question

Question:

I am looking for a replacement boat winch My mounting plate is 4inch x 6 inch can go to 7 For your winch 315-W2000D you have two expert replies under the QandA section that contradict each other. One response shows the base dimension of 3 3/4 wide by 6 1/4 long. which would fit The other response on bolt hole spacing gives the base dimension of 5.75inch wide x 7 inch long which would not fit What is the correct base dimension of the winch? Im looking for a two speed winch with strap, to replace a DL1402 single speed winch

asked by: Gary R

0

Expert Reply:

The base dimensions are indeed 6-1/4" long x 3-3/4" wide for the 2-Speed Boat Trailer Winch with 20' Strap - 2,000 lbs # 315-W2000D.

expert reply by: Kyle S

0

Answer 1

The height of the Fulton winch part #F142102 is 6 inches, the width is 5-1/4 inches without the handle and then with the handle is 10 inches. The length front to back is 7 inches.

view full answer...

Answer 2

The size winch that you will need depends on a couple of different factors. I have included part of our hand winch FAQ below regarding boat winches and have linked the FAQ article for you to view. Finding the Right Capacity Winch for your Boat…

view full answer...

Answer 3

Hi Melissa, You can definitely install 2 of #YR224-5 end caps on the ends of the #DL21554 while on the #CE10305G bracket, but not with the #CE10727A roller shaft. Each end cap will add 1-1/2" of length so you would need a roller that is at least…

view full answer...

Answer 4

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 5

The closest match we have is the part #e54SR which is for a 3,500 lb axle and is 25-1/8 inches long. It would be a bit longer than what you have but it would work.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

view full answer...

Dimensions of Base of 2,000 lb 2-Speed Boat Trailer Winch with 20' Strap # 315-W2000D

Product Page this Question was Asked From

Continue Researching