Do You Offer a Replacement Motor For Weize 3,500LB Power Tongue Jack?
Question:
I am looking for a replacement motor for a #3500 Weize Power tongue jack. Motor has no markings on it. It has three leads ground and two direction leads. Spline end has two bolts. Dont see a way to send you a pic. Weize 3500 Lb. Power Tongue Jack, Heavy Duty Electric Trailer Jack with 600D Polyester Protective Cover, 23-5/8 Lift, 12V DC
asked by: Jeffery B
Helpful Expert Reply:
You are most likely going to have to replace your entire jack. In my experience the motor is typically one part when it goes on on a trailer tongue jack the manufacturer does not carry any replacements. I recommend replacing it with the Bulldog Powered Drive Trailer Jack # BD500187. The thing I like about this jack is it has a 5-year warranty, where most manufacturers only give a 1-year warranty.
You can contact the manufacturer Weize directly to determine if they have a replacement motor for your specific jack as this is a manufacturer we do not carry their products and are not aware of what support they offer.
Product Page this Question was Asked From
Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: 5th Wheel/Gooseneck 90-Degree Wiring Harness w/ 7-Pole Plug - GM, Ford, Ram, Toyota - 9' Long
- Shop: Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness w/ 7-Pole Connector - 6' Long
- Search Results: break away system
- Shop: Gooseneck Hitch
- Shop: Suspension Enhancement
- Shop: Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 10' Long
- Q&A: Installation of the Fifth Wheel and Gooseneck 90 Degree Wiring Harness
- Q&A: Recommended Air Conditioner For a 2006 Keys Trailr WIth No Existing Air Conditioner
- Q&A: Recommended Bolt On Trailer Jack with Rectangle Foot For 1,200lb Trailer
- Q&A: Economically Priced AC Unit Recommendation for Trailer Not Ducted for AC
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Jacks
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring
- Article: Trailer Wiring Diagrams
- Search Results: 44649
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Search Results: 68149
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Choosing the Right Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Search Results: 25580
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Shop: Grease Seals 10-36 (pair)