Troubleshooting Error E2 on Advent Air AC Unit

Question

Question:

I just purchased an advent 15000 btu to replace the 13500 in my 2013 aspen trail. When I turned it on, I have a E2 code. I tried putting the condenser probe in the freezer for 30min but still have the same code. What else should I be looking at?

asked by: Larry

0

Expert Reply:

The e2 error of the Advent Air AC Units is for an Indoor Coil Temp Sensor Defect. To fix this check wire connections and ensure sensor is properly installed or replace sensor.

expert reply by: Jameson C

0

Answer 1

The Advent Air RV Air Conditioner - 15,000 Btu - White #ACM150 is designed to just replace the outside part of the AC system and utilize the old system components like the air distribution box, ducts, and thermostat. It is directly compatible with…

view full answer...

Answer 2

The "Lo" error code you are referring to on the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners #ACRG15 is stating that the DC voltage is below 10 volts. What you can do from here is check your…

view full answer...

Answer 3

For an Advent Air RV Air Conditioner #ACM135 an E5 error typically indicates a communication error between the controller and the thermostat, but it can also indicate an issue with the thermal probe. The thermal probe is typically latched onto the…

view full answer...

Answer 4

You can replace your current Dometic 300 with the Dometic Full-Timer RV Toilet #DOM27FR ( #DOM87FR for white) if you like the elongated bowl design or you can replace it with a Dometic Part-Timer RV Toilet #DOM57FR if you just want another standard…

view full answer...

Answer 5

The best option to replace your Coleman Mach 8 is one from Furrion that offers a simple plug-in that will work with your existing set up: - Furrion Chill HE Replacement RV Air Conditioner for Coleman Setup #FR42PV The Furrion Chill #FR42PV is a…

view full answer...

Answer 6

If your disc brakes like the Kodiak Disc Brake Kit #K2R35S are not releasing it is likely an issue with the hydraulic actuator. Oftentimes this is the shock of the actuator having gone bad so it won't release all the way, so that would be…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…

view full answer...

Answer 9

The Carrier Air V RV Air Conditioner is no longer produced so a direct replacement of the same unit is not an option. However, we do have available the two Advent AC models that are designed as replacement units for the Carrier Air V. I recommend…

view full answer...

Answer 10

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 11

For an RV with a currently installed Dometic Duo-Therm 59516.531 AC unit, I recommend the Advent Air for Dometic Setups, #ACDOM150. This is a 15,000 Btu replacement option that plugs directly into your current Dometic setup and works seamlessly…

view full answer...

Answer 12

Hey William, so the Advent Air AC unit part #ADV64FR would be a solid 15k BTU rated replaced for your setup. It is designed for ducted applications like you'd need as well. This also will wire right up to Advent and Dometic setups but if you…

view full answer...

Troubleshooting Error E2 on Advent Air AC Unit

Product Page this Question was Asked From

Continue Researching