Weight Capacity of Lend-a-Hand Extra Large Folding Grab Handle

Question

Question:

What is the weight spec on this product?

asked by: Randy D

1

Helpful Expert Reply:

The Lend-a-Hand Extra Large Folding Grab Handle # AM-533 does not have a specific weight capacity. According to Stromberg Carlson, this is only to assist and not weight bearing. Typically this is installed by driving the screws into a stud so it will be very sturdy.

expert reply by: Robin H

1

Answer 1

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 5

Hey Ken, so the first thing you will need is a base plate kit like the Blue Ox part #BLU85CR which fits your 2023 GMC Canyon and would be compatible with your Blue Ox tow bar. I do not know what braking system you had in the past but for a permanent…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

While we do not carry that particular Lippert step we do have the similar MORryde #MR98RR or a better option in my opinion is the TorkLift GlowStep #TLA9104. I prefer this step as it folds up nicely and works better in tight areas like storage lots.…

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 9

I recommend using the Roadmaster wiring for your 2024 Ford Maverick because I've found it to be the most reliable on the market. The correct kit depends on if your Maverick has LED lights or not: - LED Lights #RM38FR - Non-LED Lights #RM-15267…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Here are the steps to prepare your 2023 Ford Bronco Big Bend for flat towing. The transfer case and transmission will be in neutral with the ignition off. This information is in your owners manual. Switching Neutral Tow On 1.Switch your vehicle to…

view full answer...

Answer 12

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Weight Capacity of Lend-a-Hand Extra Large Folding Grab Handle

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching