Where Does the Replacement Hall Effects Wiring Harness Get Routed To?

Question

Question:

YOU STATE THIS HARNESS GOES BETWEEN THE TWO CENTER JACKS.. DOES THIS RUN FROM THE CONTROLLER UP FRONT DIRECTLY TO THE LEFT CENTER JACK. SHOW PICTURES IF AVALIABLE. THANKS

asked by: WAYNE C

1

Helpful Expert Reply:

While we do not have a picture showing this harness installed, I can tell you that the Replacement Hall Effects Wiring Harness # LC347013 you're looking at does go from the controller directly to the jacks on the left side and # LC347012 would go from the controller to the right side jacks.

expert reply by: Bryce D

1

Answer 1

For your 4 point Lippert Ground Control leveling system the correct wiring harness you need for the right/rear jack is the part #LC65ED and then for the correct replacement jack you would need the part #LC428493 and you'd be set with…

view full answer...

Answer 2

The Ground Control jacks for travel trailers are different as they are a C-jack instead of a vertical lift. I recommend using the Replacement C-Jack for Lippert Components Electric Ground Control TT #LC404488 for that application instead of…

view full answer...

Answer 3

Since you have the 4-point Ground Control 3.0 #LC358590 the correct replacement right rear leg is part #LC344792.

view full answer...

Answer 4

In the picture you sent it appears that the white connector is the one that is actually broken. It looks like the black connector just ripped completely off the board and should be able to be disconnected from the wiring harness and the wiring…

view full answer...

Answer 5

Yes it does, what you will need are 1/2"-20 self-tapping bolts in order to install the bracket you asked about: - Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 #LC349975

view full answer...

Answer 6

I reached out to my contact at Lippert and he mentioned that the Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 #LC349975 has holes that are 0.57" diameter and designed for use with 1/2" diameter bolts.

view full answer...

Answer 7

I have attached for you below the complete dimensions of the Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 part #LC349975 to the degree that Lippert was willing to share. If you require further dimensions, I'd need to know…

view full answer...

Answer 8

It sounds like you just need to reset the zero point. In order to do this you will need to follow the steps I have attached for you below and in the photo. If this does not fix your issue then please just let me know and I will see if we have any…

view full answer...

Answer 9

If you have the Ground Control 3.0, you need the Replacement Control Module part #LC304136 for 4-Point or part #LC85ED for 6-Point. If you need the control panel, that's the Replacement Control Panel for Lippert Ground Control 3.0 and Travel…

view full answer...

Answer 10

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

view full answer...

Where Does the Replacement Hall Effects Wiring Harness Get Routed To?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching