Middle Jacks Will Not Fully Extend on Lippert Ground Control 2.0 6-Point System
Question:
When the auto level button is pushed the landing legs and the rear jacks extend fine. The mid jacks however only extend a couple of inches and then stop before they touch and then the control panel beeps as if it’s completed the leveling process.
asked by: Michael
Expert Reply:
It sounds like you just need to reset the zero point. In order to do this you will need to follow the steps I have attached for you below and in the photo. If this does not fix your issue then please just let me know and I will see if we have any other actions for you to preform.
1. Manually run the jacks to level the unit. This is best achieved by placing a level in the center of the unit and leveling it both front to back and then side to side.
2. Once the unit is level, turn off the touch pad.
3. With the touch pad off, press and release the “front” button 10 times and then press and release the “rear” button 10 times.
4. The touch pad will flash and beep and the display will read “zero point calibration enter to set, power to exit” (Fig. 5).
5. To set the current position as the zero point, press the “enter” button.
6. LCD display will read “zero point stability check” (Fig. 6).
7. LCD display will read “zero point set successfully” once process is complete (Fig. 7).
8. The system will set this point as its level state and the touch pad will turn off.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Motor Upgrade Kit for Kwikee Electric RV Steps
- Q&A: How to Clear Error Code on Lippert Ground Control Leveling System
- Q&A: Troubleshooting LCI 3.0 Six Jack Auto Leveling System on Jayco Camper
- Shop: Replacement Gear Box and B Linkage for Kwikee Electric RV Steps
- Shop: Replacement Heavy-Duty Landing Gear Jack Leg for Ground Control 2.0 - Short
- Q&A: Middle Jack Isn't Working on a Lippert 3.0 LC675817
- Shop: Replacement Heavy Duty Driver Leg for Lippert Ground Control 2.0 Landing Gear
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Shop: Suspension Enhancement
- Shop: Replacement Crown Gear for Lippert RV Slide-Out Mechanism
- Shop: Replacement Hall Effect Motor for Lippert Components Ground Control 3.0 Leveling System
- Shop: Replacement Wiring Harness for Lippert Ground Control 3.0 RV Landing Gear - Front Driver's Side
- Q&A: Lippert 2.0 Ground Control Landing Gear Problem Solution
- Q&A: How to Clear Out-of-Stroke Error Message on Lippert Ground Control System LC358590
- Shop: Truck Bed Tailgate Assist
- Shop: Tailgate
- Q&A: How to Wire Two 6-Volt Batteries In Series to Double Output Voltage
- Search Results: kwikee steps
- Video: Review of Lippert Trailer Jack - Replacement Short Jack Leg - LC241844
- Video: Review of Kwikee Control Unit to Motor Pigtail Connection - LC379164
- Shop: RV Jack Pads
- Search Results: air lift
- Search Results: 15a male to 50a female
- Search Results: 50a to 30a adapter
- Search Results: tow bar
- Search Results: dm9523127
- Search Results: bx88185
- Article: How to Service An RV Air Conditioner
- Video: Review of B and W Gooseneck and Fifth Wheel Adapters - Adapts Truck - BWRVK3050
- Video: Review of Camco RV Sewer - RhinoFlex Hose - CAM39761