Replacement Hall Effects Wiring Harness - Right Side

Video Transcript for Review of Lippert Components Landing Gear Parts - Replacement Wiring Harness - LC347012

Ellen: Hey everyone, I'm Ellen here at etrailer.com. And today we're taking a look at the Replacement Hall Effects wiring harness. This is going to be the harness for your right side of your trailer with the Lippert ground control landing gear. That's going to be the 6-point set. And this is going to go between your two smaller landing gear pieces. Measures about 33 feet long, roughly.

So it should be enough to route through your trailer and get everything connected. As far as the connectors, wanna make sure that you get a good look at those to make sure that they match with your application. Not that these are going to fit into each other, but just that they should fit into the rest of your stuff.So, it should be a match for you. This is just one wiring harness. Again, that is what about go on the right side or your passenger's side.

Again, between the two smaller landing gear. It is housed is in a nice wire loom. So it should keep that wire protected from any kind of damage. And that's about all there is to it for this replacement wiring harness. I hope this video's been helpful in deciding if this is going to be the right one for you.

If not, we do have other replacement parts here at etrailer.com to get you back out on the road and enjoying your adventure. Thanks for watching.