Replacement Spring Bar Retainers For a Round Bar Weight Distribution Hitch System

Question

Question:

I’m looking for the round pins that hold the weight distribution bars to the head piece. There held in place by spring clips

asked by: Bennett B

0

Expert Reply:

We currently have the Spring Bar Retainers from Curt # 17109 and Fastway # FA94-02-1059.

expert reply by: Bud M

0

Answer 1

We have a few different clip options that are possible fits for your Weight Distribution (WD) system. Fastway WD - FA94-02-1059 Curt WD - 17109 From the picture that you sent me, I believe that the Curt clips #17109 are the correct replacement clips…

view full answer...

Answer 2

Reese does not offer the spring bar retainer clips like you have referenced. The really good news is that you can use either the Replacement Spring-Bar Release Clip #FA94-02-1059 or Curt #17109. These clips will work as replacements for the hitch you…

view full answer...

Answer 3

As far as I know this is not a common problem, and not something that we have had reported as an issue for the #FA94-00-1000. It is important to make sure that everything is secure when installing the weight distribution hitch. The spring bars should…

view full answer...

Answer 4

Sounds like you are looking for the Replacement Spring-Bar Release Clip for Fastway e2 Weight Distribution Systems with Round Bars #FA94-02-1059 which is the correct release clip for the Fastway e2 round bar weight distribution systems.

view full answer...

Answer 5

It sounds as if you're needing the spring bar retainer clip kit. If you have the Curt or a Reese Round Bar system, use #17109 which includes 2 clips, 2 lock pins and two drive-in rivets. The exact kit needed will depend on which…

view full answer...

Answer 6

Sounds like you have a Fastway E2 weight distribution system and need new release clips to replace lost ones. For that you'd want the part #FA94-02-1059.

view full answer...

Answer 7

First you have to get the lower screw out of the head of the system. Since the screws don't have a slot or Philips head on them you'll have to pry them out some have to use a chisel. Once they are out you'll slide the clip down so that it…

view full answer...

Answer 8

Brent, to remove the Replacement Spring-Bar Release Clip for Fastway e2 Weight Distribution Systems with Round Bars #FA94-02-1059 you are going to need to start by getting the lower screw out of the clip which you're going to need to pry out…

view full answer...

Answer 9

It sounds like you might need the clips that hold your round spring bars in the head unit. If you have a Fastway e2 system then their Replacement Spring-Bar Release Clips #FA94-02-1059 are the correct part. If you have a Curt system use their part…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...