Can Furrion Vision S 4.3" Monitor Be Upgraded to 7" Monitor for Use with Side Cameras

Question

Question:

I have a Furrion F0543TADS camera and monitor. Can I upgrade to 7inch monitor. Also will side cameras work with this?

asked by: Howard W

0

Expert Reply:

Yes, you can replace your 4.3" Furrion Vision S monitor with the 7" Monitor # FR47FR, which will then allow you to use the LED Marker Light RV Side Cameras # FCE48TASL.

Please note you also need the Suction Cup Mount # FR79SR since this is a larger monitor than what you currently have.

expert reply by: Jon G

0

Answer 1

The Suction Cup Mount #FR79SR is the only mount we carry for the 7" Monitor #FR47FR. This mount has a 0.85" mounting ball which you may be able to find for different devices. You may be able to use a dash mount pad to hold the suction cup…

view full answer...

Answer 2

The Replacement 7" Monitor for Furrion Vision S Wireless RV Camera System Item #FR47FR will replace your current 4.3" Monitor and allow you to add additional cameras to your system if needed.

view full answer...

Answer 3

You can upgrade your monitor to the 7 inch version with part #FR47FR. Your power cable can be reused but you'll need a new mount #FR79SR.

view full answer...

Answer 4

The Furrion cameras, like what comes in the part #FOS43TASF that replaced the part you referenced, are only compatible with their specific monitors. If you are looking for a camera system that allows you to use your smartphone as the monitor then I…

view full answer...

Answer 5

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 8

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 11

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 12

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Can Furrion Vision S 4.3" Monitor Be Upgraded to 7" Monitor for Use with Side Cameras

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching