Is There an Extendable Monitor Mount For Furrion Vision S 7" Monitor?

Question

Question:

Is there a extendable monitor mount for Vision S monitor , windshield mount .

asked by: Alan A

0

Expert Reply:

The Suction Cup Mount # FR79SR is the only mount we carry for the 7" Monitor # FR47FR. This mount has a 0.85" mounting ball which you may be able to find for different devices. You may be able to use a dash mount pad to hold the suction cup mount where it is more easily in view. These can be found at most local electronics stores.

expert reply by: Bud M

0

Answer 1

The Replacement 7" Monitor for Furrion Vision S Wireless RV Camera System Item #FR47FR will replace your current 4.3" Monitor and allow you to add additional cameras to your system if needed.

view full answer...

Answer 2

Yes, you can replace your 4.3" Furrion Vision S monitor with the 7" Monitor #FR47FR, which will then allow you to use the LED Marker Light RV Side Cameras #FCE48TASL. Please note you also need the Suction Cup Mount #FR79SR since this is a…

view full answer...

Answer 3

There are adapters on the market that can go from a cigarette lighter style plug that the #C-FOS07TAPK-006 has to USB/USB-C ports but we don't currently offer any so the only solution I can provide is the #RM-9332. This is a replacement outlet…

view full answer...

Answer 4

You can use a NOCO Extension Cable #329-GC019 to route the Power Cord #C-FOS07TAPK-006 for your Furrion Vision S 5" Monitor System #FOS05TASF. The extension is 12' long and the extra wire will not affect the power going to the monitor. For a…

view full answer...

Answer 5

Currently the Furrion Monitor Power Cable #C-FOS07TAPK-006 is the only available power cable for the Furrion Vision S Wireless RV Backup Camera System #FOS05TASF. There are AC to DC Adapters like #PP01 that you can use to plug the included power…

view full answer...

Answer 6

I do have a solution, but unfortunately a power cable like the #C-FOS07TAPK-006 is the only way to power your Furrion monitor at this time. What you will need to do is add the 12 Volt Outlet Kit, 20 amps #RM-9332. This will give you the socket you…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Is There an Extendable Monitor Mount For Furrion Vision S 7" Monitor?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching