What is the Weight of the etrailer Hitch e55ZR for a 2019 Subaru Ascent?

Question

Question:

How much does a e55ZR weigh?

asked by: Richard

1

Helpful Expert Reply:

The etrailer Hitch item # e55ZR weighs 31 lbs. This hitch is confirmed to fit your 2019 Subaru Ascent.

If you are planning on towing you will also need a wiring harness item # C56040 and a ball mount kit item # C45534.

I have linked a couple of installation videos below.

expert reply by: Jerred H

1

Answer 1

The etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish tem #e23ZR for your 2020 Toyota RAV4 weighs 38 lbs.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Yep, so long as your 2024 Subaru Crosstrek Wilderness is not a hybrid both the Curt and etrailer hitches will fit: - Curt Trailer Hitch Receiver #C13382 - etrailer Trailer Hitch Receiver #e98912 The only difference besides price is the finish; the…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 8

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

Since you have the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" Item #C13200 on your 2017 Toyota Highlander you aren't limited to a certain type of rack because your hitch is a class III hitch receiver. Both the Thule Apex XT 4…

view full answer...

Answer 11

For me there is one clear choice between the two bike racks you asked about, and for one very particular reason - convenience. Due to how convenient it is, I definitely recommend the RidgeBack, which is the following part number: - Yakima RidgeBack…

view full answer...