Recommended Removable Wheel for Trailer Valet JXS Trailer Jacks

Question

Question:

Trailer Valet JXS Trailer Jack w/ Footplate and Drill Powered Option - Side Mount - Sidewind - 5K Item # TV64FR Can I get this with a wheel instead of the foot plate?

asked by: Robert R

0

Expert Reply:

There is an option to add a wheel to the Trailer Valet JXS Trailer Jack item # TV64FR, however it has to be purchased separately. They aren't available to be purchased together. You will want the Removable Wheel for Trailer Valet JXS Trailer Jacks item # TV89FR.

expert reply by: Jerred H

0

Answer 1

The mounting bracket for the #TV34FR is actually identical to the bracket on the #TV64FR that you were looking at. The holes are 1" apart on center vertically, and 5-1/2" apart horizontally. I have attached a picture for your reference.

view full answer...

Answer 2

The Dutton-Lainson Square Swivel Jack #DL22340 has a mounting plate designed to fit trailer frames with a height of 3" - 5". I have attached a dimensional drawing below with all of the bolt spacing for your reference.

view full answer...

Answer 3

To add a hitch to your 2024 Jeep Grand Cherokee L, I recommend the Draw-Tite item #DT42GR. This hitch is custom fit and bolts to your Jeep with included hardware. This is a class III hitch with a 2" receiver. It has a 7,500 lbs towing capacity…

view full answer...

Answer 4

Hey William, the E6 error on a Furrion wall thermostat indicates an Open circuit Humidity Sensor issue. Most likely the sensor is bad and needs to be replaced as this is a pretty rare error code.

view full answer...

Answer 5

The Trailer Valet #TV64FR JXS 5K trailer jack is a pipe mount swivel jack that can be removed from the trailer by pulling the pin shown in the provided photo. If you click the provided link, you can see a video showing a typical installation.

view full answer...

Answer 6

The mounting plate for the Trailer Valet JXS Trailer Jack #TV64FR has bolt holes that are separated on center 5-1/2" horizontally. The vertical mounting holes are separated on center 1" each for a total of 5" from the top hole to the…

view full answer...

Answer 7

Hi Robert, If you're just wanting to replace the condenser unit on the rooftop and retain use of your current air distribution box and thermostat then you'll just need to determine what style connector your current unit has. If you remove the…

view full answer...

Answer 8

The Trailer Valet #TV64FR JXS Trailer Jack has a 3000 lb lift capacity, and offers a 14 inch lift. It doesn't feature a drop leg.

view full answer...

Answer 9

The Trailer Valet JXS Trailer Jack #TV64FR is going to be the closest option we have to what you are wanting. This jack does have a pipe type mount but you must use the included mounting bracket pipe mount since the pipe is different from a…

view full answer...

Answer 10

The jack mounts used on a-frame trailers usually follow an industry standard pattern which is a 2-1/4" hole opening and three mounting holes spaced 3" apart. I have attached a photo to show this for you as well. If your trailer coupler does…

view full answer...