Replacement Circuit Board for MaxxAir RV Roof Vent with Motor 10-20968

Question

Question:

I have a Maxx Air p/n 10-20968. I believe i need to replace the mother board. What part number should I be ordering? Thank you.

asked by: Pete A

0

Expert Reply:

Based on the part number of your motor the correct circuit board would be the part # MA10A21275K.

expert reply by: Jameson C

0

Answer 1

What I think you are asking is if either the Replacement Wall Control Panel for MaxxAir MaxxFan Plus Roof Vent, #MA59FR or, the #MA00A03550K can be used with a MaxxFan - 00-04951KSX. The #MA59FR controls the 10-speed fan, electric lift lid,…

view full answer...

Answer 2

Your MaxxFan Plus Roof Vent #MA00-04500K uses the Remote #MA00A01150K. The Key Wall Control #MA00A03550K is not compatible with your fan.

view full answer...

Answer 3

The replacement circuit board for your MaxxFan 4201 Series is the Replacement Printed Circuit Board and Switch for MaxxFan 4301 Series Roof Vents #MA10-04301K-V16. The 4201 series circuit boards may look different compared to the upgraded circuit…

view full answer...

Answer 4

For your MaxxFan part #MA00-07500K that you referenced the correct replacement motor is the part #MA10-20968 that you referenced. The motor comes with connectors that will attach to the circuit board that controls the motor which is part #MA10A21275K…

view full answer...

Answer 5

It is possible the Replacement 12-Volt Variable Speed Fan Motor for MaxxAir MaxxFan RV Roof Vents #MA10-20968 will work as a replacement for the 10-20965 motor, but it actually depends on the model of MaxxAir fan you have. It is likely this will…

view full answer...

Answer 6

I can't find any info on the part number you mentioned but could I maybe see a picture of the and/or know what specific fan you have installed?

view full answer...

Answer 7

For a great low-profile toilet, I recommend the Dometic 311 Part-Timer RV Toilet - Low Profile #DOM67FR. Not only does this toilet only measure 15-1/2 inches high, I confirmed with Dometic that the trap stays open while the pedal is compressed. The…

view full answer...

Answer 8

To properly install The Replacement Key Wall Control For MaxxFan Plus and Deluxe - 4 Key #MA00A03550K you will need The Communication Cable #34279523. I attached a review video link below.

view full answer...

Answer 9

A 4-wire phone cable is not something that we are aware can be used instead of the Replacement Control Cable for MaxxAir MaxxFan Plus Roof Vent Wall Control Panel #MA69FR. This is what you would need as opposed to a phone cable for models 00-04500K,…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

Answer 12

The model number for fans such as the MaxxAir MaxxFan Mini Roof Vent, #MA00-04401M is listed on the upper side of the assembly itself. Please see the attached image. You will best identify this by opening the vent and climbing on top of the RV.…

view full answer...