Recommended Front & Rear SumoSprings for a 2005 Fleetwood Bounder Workhorse 32W

Question

Question:

I am need SumoSprings for front and back axles. 2005 Fleetwood Bounder Workhorse 32W

asked by: Mike U

0

Expert Reply:

For your 2005 Fleetwood Bounder Workhorse 32W Motorhome you can use the SumoSprings Solo Custom Helper Springs # SSF-280-47 for the front axle and the SumoSprings Maxim Custom Helper Springs # SSR-280-54-1.

The front springs have a maximum weight capacity (at 50%) is 1,500-lbs, and 7,000-lbs for the rear, and will work in temperatures ranging from -25°F to 200°F.

expert reply by: Bryce D

0

Answer 1

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 2

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 3

The air suspension system on your 2022 Ram 2500 limits your options for suspension enhancement. None of the air bags made for your truck will be compatible. Instead, I recommend adding the SumoSprings Rebel Custom Helper Springs #SS64VR. The…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

Hey David, actually what is going to make the biggest improvement in handling and stability for your 2011 Itasca is an upgraded rear sway bar with the part #RM-1139-175. I know that's not what you asked about but for motorhomes where most of the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Answer 8

Hi there David; we do have truck camper jacks that can work for your F-250 with a lift and large tires. What you can use are camper jacks from Brophy, which have a 17" to 67" lift range, which is the highest possible lift height. There are…

view full answer...

Answer 9

I would be happy to! To flat tow your 2024 GMC Canyon Denali you will need the following parts: Tow Bar and Safety Chains - Roadmaster Nighthawk All-Terrain Tow Bar w/ LED Lights item #RM-676 Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit…

view full answer...

Answer 10

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

view full answer...

Answer 11

For your 2024 Ford F-53, I recommend checking out the Timbren Front Suspension Enhancement System #TFFF53B for the front, and the Timbren Rear Suspension Enhancement System #TFRF53A for the rear. These kits do not require drilling, will replace your…

view full answer...

Answer 12

We have the SumoSprings #SSF-280-47 that will fit the front of your 2005 Coachmen Aurora if you have the Workhorse chassis. We also have the Rear #SSR-280-54-1 for the same chassis if you need them as well. If your Aurora was built on a different…

view full answer...