Replacement Screws For Attaching The Top Cover To A Lippert Electric Trailer Jack

Question

Question:

I am looking to replace the screws in the top cover for a lippert 285318. I have the jack but not the old screws so looking for size and pitch on replacement screws..Thanks for your time...

asked by: Kevin

0

Expert Reply:

Lippert was unable to provide me with the screw they use so I pulled the # LC285318 from the warehouse and removed the screws to measure them and found them to be 3/4" - #8 screws. You'll need four of them (two up front & two in back) to mount your replacement cover # LC285160 on the jack.

expert reply by: Kevin C

0

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 3

I would be happy to. To flat tow your 2017 Ford F-250 you will need the following parts: Tow Bar and Safety Chains - etrailer XHD Non-Binding Tow Bar item #e84ZR Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Removable Arms item…

view full answer...

Answer 4

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 5

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 6

Hey David; I checked directly with Pace Edwards for you and can tell you that the rails on the Pace Edwards Switchblade Retractable Hard Tonneau Cover #PE46QJ will protrude just under 3/4" on both sides when installed on your Ford Super Duty…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Lippert does not offer a replacement inner jack tube for their jack 1817941. When a jack is damaged in this way (which is more common than you want to know) it really is best to replace the entire jack for safety reasons. The outer tube on your jack…

view full answer...

Answer 9

Your typical electric jack is designed to fit an A-frame so the only one we carry that is a side mount is the Fulton XLT #F141401. However, you may be interested in the Trailer Valet JXS Drill Powered Swivel Trailer Jack #TV64FR. This jack has a hand…

view full answer...

Answer 10

Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…

view full answer...