Does Trailer Tongue Length Have an Affect on Axle Placement
Question:
I am building a 10’ trailer with a 48”tongue. Does the formula work for a short trailer? Including the tongue in D in the measurement for axle placement? This will put the axle closer to the center of the 10’ deck before adjustments to compensate for tongue weight.
asked by: Greg J
Helpful Expert Reply:
The formula used for determining trailer axle placement (attached below) is just a general guideline. If you're building a trailer with a longer/shorter tongue than a standard trailer would have you may need to adjust these measurements. That said, we aren't custom trailer builders so we really can't provide specifics and the final location will be up to the installer.
If you need the hardware to attach your axle to the frame, I recommend the Single-Axle Trailer Hanger Kit for Double-Eye Springs part # APS4.
Product Page this Question was Asked From
Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear
- Trailer Leaf Spring Suspension
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Single Axle
- etrailer
more information >
Continue Researching
- Q&A: How Far Apart Should Hangers be Mounted for 27 Inch Leaf Springs
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Q&A: How to Raise the Height of a Boat Trailer to Avoid Scraping on Inclines
- Q&A: Installing Leaf Springs on Single Axle Trailer
- Q&A: Hanger Placement with 3,500 lb Axle with Hanger Kit part # APS4 On Trailer with Axles Under Springs
- Shop: Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear
- Search Results: small trailer axle
- Article: Trailer Tire Sizing
- Shop: Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 72" Long - 2,000 lbs
- Shop: Yates Side Guide Roller for Boat Trailers - Heavy-Duty Rubber - 12" Long - 5/8" Shaft
- Shop: Single Axle Trailer Fender w/ Backing Plate - Steel - 13" to 14" Wheels - Qty 1
- Shop: Yates Side Guide Roller for Boat Trailers - Heavy-Duty Rubber - 12" Long - 1/2" Shaft
- Shop: Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers
- Shop: Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 72" Long - 2,000 lbs
- Search Results: flat bottom boat rollers
- Search Results: boat roller
- Search Results: trailer jack
- Article: Trailer Wiring Diagrams
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Article: Most Popular Wheel Bearings
- Search Results: axle
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Q&A: MORryde Cushioned Pin Box For 2024 Brinkley Model Z 3610 w/ Lippert Rhino Pin Box
- Shop: Suspension Enhancement
- Search Results: leaf spring
- Shop: Fifth Wheel Hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)