Heavy Duty 2-5/16" Bolt On Trailer Coupler Made In The USA

Question

Question:

Im looking for a 2 5/16 trailer coupler heavy duty bolt on. That is made in USA, do you have any?

asked by: Chad W

0

Expert Reply:

We have the Demco Channel Tongue Trailer Coupler # DM16080-52 for a straight tongue and the Demco 50-Degree A-Frame Trailer Coupler # DM16680-52 for A-Frame. Both are made in the USA, are bolt on and rated for up to 21,000lbs. Both come with the eZ-Latch coupler to make connecting to your trailer easier.

expert reply by: Bud M

0

Answer 1

I did pull the Titan Zinc-Plated Straight-Tongue Coupler - 21,000 lbs #T4853100 and measured from the inside top of the coupler to the center of each of the 5 bolt holes from back to front: 2" 1-1/4" 1" 1"…

view full answer...

Answer 2

If you wanted to drill holes in the Demco Coupler #DM13203-95 to make it easier to attach to your trailer frame you certainly could. Just be mindful where you drill the holes and don't turn it into swiss cheese. When it's time to pick…

view full answer...

Answer 3

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 4

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 8

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

view full answer...

Answer 9

The Dexter Electric Trailer Brake Kit #23-105-106 are a replacement set for the 023-358-00. This kit includes a right and left brake assembly that is manually adjustable. I recommend the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 as…

view full answer...

Heavy Duty 2-5/16" Bolt On Trailer Coupler Made In The USA

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching