What Trailer Axle Spindle Has Bearings L68149 and L44649

Question

Question:

bearing number L68149 larger one L44649 is the smaller bearing napa part number 27 supplier SKF, elgin, IL

asked by: Kelly

0

Expert Reply:

If you know the trailer axle capacity that's a pretty good way to determine what spindle you have. Or if you get me the bearing numbers. You can also measure the spindle where the bearings ride and with that info I can let you know what you have.

expert reply by: Jameson C

0

Kelly

1/19/2023

bearing number L68149 larger one L44649 is the smaller bearing napa part number 27 supplier SKF, elgin, IL

Reply

Jameson C.

1/19/2023

Thanks! Based on that you have the very common 3,500 lb trailer axle spindle like the part # TRU24FR that you referenced.

Reply

Answer 1

The answer to your question will depend on if you have hub centric or lug centric wheels. What's the difference? Lug centric wheels use wheel studs embedded in the hub and lug nuts to attach the wheels. The wheel studs provide all the support for…

view full answer...

Answer 2

A true 1 inch spindle is a BT8 spindle, like #TRU94FR. The next closest one would be the BTR spindle which is commonly referred to as a 1-1/16 inch spindle, like #TRU44FR and is more common than the BT8. Both of these are typically used with 2,000 lb…

view full answer...

Answer 3

Thanks for providing all of the information for your axle. This axle is going to use the standard 3,500 lb axle bearing sizing. You can use the Bearing Kit #BK2-100, which will come with bearings, races, seals, cotter pin and tang washer - everything…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

If you remove the hub and wipe away the grease on the spindle you can check to see if it is damaged. Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can…

view full answer...

Answer 6

Tire designations ST205/75D14 and ST205/75R14 are both for special trailer tires with a 205mm width, 75-percent aspect ratio and that fit a 14-inch wheel. The difference between them is the tire's type of construction. The ST205/75D14 tire is a…

view full answer...

Answer 7

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

view full answer...

Answer 8

Brake calipers are typically installed so they point toward the back of the trailer, but it is okay to install them pointing up or toward the front of the trailer. The important thing to consider when installing the calipers is to make sure at least…

view full answer...

Answer 9

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

view full answer...

Answer 10

The difference between the single lip and double lip seals is that the double lip grease seal will have two rubber lips that are in contact with the spindle. The double lip grease seals are usually used in marine applications to give a better seal…

view full answer...

Answer 11

Polyurea is in the wheel bearing grease and is compatible with marine bearing grease but not the Red grease. Red grease is compatible with marine grease but not standard. I attached a help article that has a chart with all of the grease…

view full answer...

Answer 12

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…

view full answer...

What Trailer Axle Spindle Has Bearings L68149 and L44649

Product Page this Question was Asked From

Continue Researching