Replacement Brake Magnet Size for a 2007 Weekend Warrior FS23

Question

Question:

What size magnet for trailer brakes on my 2007 weekend warrior fs23 use

asked by: James B

0

Expert Reply:

It looks like your 2007 Weekend Warrior FS23 has a GVWR of 7,650 lbs so it likely has dual 3,500 lb axles. This means you'll need a brake magnet for 10" brake assemblies.

For your application you can use part # BP01-110 for Dexter and Hayes / AL-KO 10" Trailer Brakes or part # AKBRKR-M10 if you have a different brake assembly brand like AxleTek, Dexter, Lippert (LCI), IAC, and AL-KO.

Attached are some videos for you to check out. Let me know if you have any other questions!

expert reply by: Jon G

0

Answer 1

There should only be power entering the brake magnets, not leaving them through the ground wire. I would first start off by regrounding each brake magnets to a new bare metal surface separately of one another and as close to the brake assembly as…

view full answer...

Answer 2

There are a few different tests that can be done to check the brake magnets individually and as a whole on your trailer. I would first recommend checking the magnets for wear before going on to test for proper amperage. If the magnets show abnormal…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 7

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Replacement Brake Magnet Size for a 2007 Weekend Warrior FS23

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching