Is the NOCO Genius GEN5X2 Mini Charger Safe To Mount In an Engine Compartment?

Question

Question:

Cana NOCO Genius GEN5X2 Mini Charger be mounted inside of a ram truck engine bay? I want to mount this and plug it in when my truck is not in use for extended periods. I just don’t know if the component can withstand the heat of an engine bay when driving. I would hate to open my hood and find it melted or something. Thanks

asked by: Matt L

0

Expert Reply:

I recommend going with the NOCO Genius Multi-Bank Smart Battery Charger # NOC24FR for your Ram truck. The NOCO Genius GEN5X2 # NOC34FR has a maximum storage temperature of 140 degrees Fahrenheit and should not be mounted where it might collect dust. As your engine bay can exceed this temperature and collect dust this would not be a good option.

The NOCO Genius Multi-Bank # NOC24FR will allow you to run the included clamps or a better option would be to install the Eyelet Terminals # 329-GC002 with the included 10' extension cables to an easily accessible area on your Ram. Then you would simply connect the wiring terminals when you plan on leaving it parked for long periods of time. As the main charger can then be used on other batteries when you are using your truck you can get additional Clamps # NOC96ZR, Eyelet Terminals # 329-GC002 and an Extension # 329-GC004 for other vehicles or equipment batteries you have.

expert reply by: Bud M

0

Answer 1

Yes, you can use the NOCO GEN On-Board Battery Charger #NOC34FR on your pickup's parallel batteries without disconnecting them. If your batteries were in a series, they would have to be disconnected. Since your batteries are parallel and…

view full answer...

Answer 2

Hitch accessories end up being mostly secured horizontally in trailer hitches by the tongue weight of the accessory instead of by the hitch pin which is why hitch pin locks like the #e98881 are not not rated for shear strength. At some point it…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...