Using NOCO 2 Bank Charger With Parallel Batteries in Truck

Question

Question:

Can two bank units be used in 2 battery diesel pickup parallel systems without isolating /disconnecting the batteries?

asked by: Keith

0

Expert Reply:

Yes, you can use the NOCO GEN On-Board Battery Charger # NOC34FR on your pickup's parallel batteries without disconnecting them. If your batteries were in a series, they would have to be disconnected. Since your batteries are parallel and maintain a 12v load but have increased amp capacity, then it is actually ideal to have both of them charging with these banks. Just make sure each bank is connected to its own 12V battery.

One thing to note is that the NOCO Gen5x2 # NOC34FR is the mini (but also newer) 2 bank charger and it charges 5-amp per bank. If you need a little more charging amperage, we also have the NOCO Gen2 # NOC64FR which is a bit larger but also charges 10 amps per battery bank.

expert reply by: Evangeline M

0

Answer 1

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 2

I was able to cross reference the Dexter Hub/Drum 8-415 to the Dexter Trailer Hub Drum Assembly part #8-430-5UC3 which should be an exact replacement. I don't have any depth measurements of the above/drum but what you would need to measure…

view full answer...

Answer 3

Many times Dexter hubs will fit on a Lippert axle, but Lippert does have a few axles out there with special spindle sizes. Every Lippert axle comes with a tag or plate on the axle that gives a serial number or NV number. If you can give me that…

view full answer...

Answer 4

The brake controller/tow package connector is located in the black junction box on the firewall above where the driver's left foot would sit and behind the e-brake pedal. You'll need to remove the cover from the junction box, the connector is…

view full answer...

Answer 5

The Bargman breakaway switch that you have is still sold to this day. Basically, you can use any breakaway switch that you would like. They are a very simple device. Once the pin is pulled it completes the circuit from the breakaway battery and the…

view full answer...

Answer 6

You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same, etc..…

view full answer...

Answer 7

Although the TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box #TLA7727 was originally designed for attaching to the frame of a truck you certainly could attach it to the frame of a trailer.

view full answer...

Answer 8

Hitch accessories end up being mostly secured horizontally in trailer hitches by the tongue weight of the accessory instead of by the hitch pin which is why hitch pin locks like the #e98881 are not not rated for shear strength. At some point it would…

view full answer...

Answer 9

I recommend going with the NOCO Genius Multi-Bank Smart Battery Charger #NOC24FR for your Ram truck. The NOCO Genius GEN5X2 #NOC34FR has a maximum storage temperature of 140 degrees Fahrenheit and should not be mounted where it might collect dust. As…

view full answer...