Will Progressive Dynamics Inteli-Power RV Converter 60 amp Charge 2 100-Amp Hour Batteries

Question

Question:

everything I need to change from IP 9200 series PD9245C converter to PD9160ALV. Is this 60 amp large enough to charge two 100 AH lithium batteries?

asked by: Ernest L

0

Expert Reply:

The Progressive Dynamics RV Converter part # PD9160ALV would easily be able to charge two 100 ah lithium batteries. As long as you have a thick gauge wire for the batteries from your old setup this would work fine since you'd be going from a 45 amp to 60 amp setup.

expert reply by: Jameson C

0

Answer 1

The Progressive Dynamics PD9100L Series Battery Converter Charger w/ BMS #PD9160ALV that you referenced is definitely the current version of the converter. At this time that would be the 2023 version.

view full answer...

Answer 2

Yes, the Progressive Dynamics RV Power Control Center part #PD4560K18LS8 is actually designed specifically for a 50 amp service. The 60 amp rating you are seeing is for the converter output which refers to the rate that your batteries charge while…

view full answer...

Answer 3

You are correct, since you are replacing your current 60 amp converter with the Progressive Dynamics Inteli Power part #PD9160ALV the wiring you have right now would be adequate and would not require changing.

view full answer...

Answer 4

Our stock of the Progressive Dynamics Inteli-Power RV Converter and Battery Charger, #PD9160ALV are the latest available from the manufacturer and do have the Total Charging Management System (TCMS). Note however that this does NOT support the Charge…

view full answer...

Answer 5

For charging a lithium battery like what you have a 60 amp charge is quite a bit of amperage. While a higher amp charge might charge the battery faster a slower charge at 60 amps will still be very fast and honestly a better amperage to put a…

view full answer...

Answer 6

The Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9160ALV has a built in fan as well as large heat sinks on the back of it to dissipate heat so it would get warm to the touch when in use. Yes this will fully charge your…

view full answer...

Answer 7

If you've recently upgraded to lithium batteries, and that's what has precipitated your installation of the #PD9160ALV, the most likely explanation here is that your coach does not have the appropriate gauge wiring between the batteries and…

view full answer...

Answer 8

It can be tricky to pick out the correct size inverter for a trailer as the main contributing factor is really the load from the electronics, not necessarily the battery size. Therefore, even if the battery/batteries have been changed it is best to…

view full answer...

Answer 9

The correct converter is going to depend on the battery/batteries you are charging. The Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9160ALV is likely going to be a great option for you. It is going to work with Lithium…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Will Progressive Dynamics Inteli-Power RV Converter 60 amp Charge 2 100-Amp Hour Batteries

Continue Researching