Recommended In Bed 7-Way Wiring Harness for 2023 Chevy Silverados

Question

Question:

Hi, I have a 2023 2500hd. It has the factory 7 pin plug at the bumper, but I want to add one in the bed. Can you tell me the wiring harness I need? I want to keep the one on the bumper also. I am looking for the one like you t in, and connect behind your tail light. Thank you

asked by: Amy

0

Expert Reply:

To add a 7-way connector to the bed of your truck and keep the one on your bumper you will want the Demco 5th Wheel/Gooseneck 90-Degree Wiring Harness with 7-Pole Plug item # DM8555002. This wiring harness is confirmed to fit the new 2023 Chevy Silverados.

I have linked an installation video below.

expert reply by: Jerred H

0

Answer 1

We do have air bags that will fit your 2023 Chevy Silverado 2500. I recommend the Air Lift LoadLifter 5000 Air Helper Springs #AL57341. These have a load-leveling capacity of 5,000 lbs and will help keep you level while towing and hauling. They…

view full answer...

Answer 2

We don't have a 7-way splitter like the photo you sent. We instead for applications just like yours recommend using the Mighty Cord 5th Wheel/Gooseneck Wiring Harness w/ 7-Pole Connector - 7' Long #A10-7007 or the 10 foot long #A10-7010. This…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Recommended In Bed 7-Way Wiring Harness for 2023 Chevy Silverados

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching