Channel Width and Height of Buyers Products Pintle Loop and Channel part # 337B20143

Question

Question:

Can I get the length and width dimensions of the adjustment bracket?

asked by: Colton

1

Helpful Expert Reply:

The overall height of the bracket of the Buyers Products Pintle Loop and Channel part # 337B20143 is 7-5/8 inches. The overall width is 4 inches.

expert reply by: Jameson C

1

Bracket Dimensions of Channel
(click to enlarge)

Answer 1

For a 20k lunette ring we have the part #337B16140 for just the ring or part #337B20143 for a ring and a channel.

view full answer...

Answer 2

While trailer axles do feature an upward bend like you are describing, there isn't a particular amount/measurement that is standard across the board. This bend in the axle is designed so that it will straighten under a trailer's loaded…

view full answer...

Answer 3

I recommend replacing an entire ladder if it's damaged. You'll want to find a replacement based on the height. Such as the Stromberg Carlson #LA-401 that is 99-1/2 inches tall. They can be cut shorter to customize the length if needed.

view full answer...

Answer 4

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Between the Kuat Transfer part #KU74FR and the Swagman Chinook part #S64683 I would go with the Transfer mainly because it only touches the bikes at the tires whereas the Chinook grabs the frame of the bikes when securing. Swagman and Kuat are both…

view full answer...

Answer 7

The DeeMaxx item #DE86VR won't because of the spacing on the mounting bracket but I have a caliper that will. To replace your Tie Down Engineering 46304 caliper you will need the Kodiak Disc Brake Caliper item #KDBC225DAC.

view full answer...

Answer 8

For a replacement you need the Titan Zinc-Plated Brake Actuator #T2477600. This is the Titan Model 10 which is the same as the Dexter DX12.5 you currently have on your boat trailer.

view full answer...

Answer 9

The outer eye diameter of the Buyers Products 10-Ton Lunette Ring w/ 3" I.D. #337B16140 is 6-1/4". The mounting holes for the 5/8" hardware is space 2" on center. I have included an image with these measurements.

view full answer...

Answer 10

The Buyers Products 3-Position Adjustable Lunette Ring with 3" Heavy-Duty Channel #337B20143 will fit correctly with a Curt Pintle Hook with 2-5/16" Ball #C45908.

view full answer...

Answer 11

The center hole required for the Buyers Products 30 Ton Heavy-Duty Swivel Type Pintle Hook #337BP760A needs to be 2-1/16". I have attached a picture below of the mounting plate dimensions and hole placement.

view full answer...

Answer 12

I would be happy to make a recommendation for your ST205/75D15 tires on your 14K tandem axle trailer. Currently the tire with the highest load rating in your current tire size is the Provider ST205/75R15 Radial Trailer Tire - Load Range D #TR20515D…

view full answer...

Channel Width and Height of Buyers Products Pintle Loop and Channel part # 337B20143

Product Page this Question was Asked From

Continue Researching