Replacement 12" X 2" Electric Trailer Brake Assemblies For a 2018 Trailswest Horse Trailer

Question

Question:

I have a 2018 trailswest 3 horse trailer with electric drums on 5200# axles. The brake backing plate has a sticker with BK-12E-02LL on it. Which brake kit should I use and can I replace it with an automatic adjustment kit?

asked by: Jarrett B

0

Expert Reply:

Yes, you can replace your current TruRyde Brakes BK-12E-02LL with the Dexter Nev-R-Adjust Electric Trailer Brake Kit # 23-464-465 or our etrailer Electric Trailer Brake Kit # AKEBRK-7-SA. Both kits are self adjusting and will fit in place of your 12" X 2" brakes you currently have. If your current hardware is worn out we do have the Mounting Bolts and Hardware # BRKH12 you will need to replace them.

expert reply by: Bud M

0

Answer 1

To verify the 12" x 2" Hydraulic Trailer Brake Shoe and Lining #BP04-160 are the correct brakes for your 1992 Escort boat trailer I will need to know the information stamped on your backing plate for your brakes. These shoes are…

view full answer...

Answer 2

We don't have replacement brake shoes that fit your assemblies but we do have replacement brake assembly sets that would work great for what you have. If you wanted a free- backing setup we have the #AKFBBRK-35-D which are also dacromet…

view full answer...

Answer 3

Replacement brakes typically correspond with the capacity of your axles. They also need to match the bolt pattern on the brake mounting flange as well as the size of your drum on the hub and drum assembly. Based on what I have found, it is likely…

view full answer...

Answer 4

Yes, there is a measurement you can take to determine what size brakes you need and if they will fit your existing drums. You will want to measure the diameter of your drums. I have included a diagram detailing the dimensions you will need to find.…

view full answer...

Answer 5

Good questions. The difference between free backing brakes like the #AKFBBRK-35-D and regular hydraulic drum brakes like #DMSB18794M-93M (referred to as duo or duel servo) is that the wheel brake cylinder has pistons on both sides of the regular/duo…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...