Does the Locking Trailer Hitch Pin # e98880 have a Weight Capacity

Question

Question:

I am looking at buying a 7683, but would like to know what pulling weight it is rated at. I will be pulling about 3500 lbs.

asked by: Phillip

0

Expert Reply:

Trailer hitch pins and locks do not have an official capacity because they would be rated well beyond what the hitch and vehicle are capable of. In other words, the hitch or vehicle would fail long before the locking hitch pin # e98880 would.

expert reply by: Michael H

0

Answer 1

We aren't manufacturers of those parts, and we don't have the testing ability in house, so I reached out to a couple of our manufacturers to see what information they could provide to try and help. I reached out to my contact at Curt…

view full answer...

Answer 2

I have attached for you below the pairing procedure for the Voyager WiSight Wireless RV Backup Camera System part #ASA84YR. Please note, a mistake I have made in the past was applying power to the camera too soon, this cannot be done until the…

view full answer...

Answer 3

Duty cycle for a compressor is how long it can run compared to the time needed to cool down. So basically just think of it in increments of an hour - a 33 percent duty cycle over an hour is 20 minutes. And 33 percent at 100 psi is the duty cycle of…

view full answer...

Answer 4

Yes, the Reese lock will work with the Curt Slim Adjustable 2-Ball Channel Mount #C46KR. You could also use the etrailer #e98882 or any other similar lock with a 5/8" diameter to secure it.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey HPA, I would go with the Air Lift kit part #AL64VJ that fits your 2019 Toyota RAV4 based on what you described and your needs. This gives you adjustable support that you can tailor as needed so that you get the exact amount of support you need…

view full answer...

Answer 7

The lock plug for the Rapid Podium Feet for Thule Crossbars #TH460R has been discontinued, unfortunately. So, your only option is to use their lock cores #TH450400 to secure your feet.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Looking at the BAL Retract-A-Spare it has a much different design than the Lippert Spare Tire Winch #LC159056 you found. You may be able to mount the new winch so it will still work on your trailer but as we do not have both the products here with…

view full answer...

Answer 10

In order to use a hitch-mounted bike rack like the Swagman Original #S64152-2 that you were looking at while towing a vehicle, you will just need to add the Roadmaster Dual Hitch Receiver Adapter #RM-077-4. This adapter will slide into the 2 inch…

view full answer...

Answer 11

Hi Tony, thanks for writing in and yes, we can 100% get your 2023 Jeep Wrangler set up to be flat towed behind your Holiday Rambler motorhome. To make it easy to order I'll go ahead and list everything out for you. - Base Plate Kit: Roadmaster…

view full answer...

Does the Locking Trailer Hitch Pin # e98880 have a Weight Capacity

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching