Availability of RV Roof Vent Cover that Has Dimensions 22-1/2" long x 20" wide x 9" high

Question

Question:

Hi , the dimensions on the one I need are 22 1/2 x 19 1/2 x 9 1/2 . the one you have is 17 1/2 width .

asked by: Agustin B

0

Expert Reply:

We have a RV roof vent cover that has dimensions pretty close to what you mentioned with the Camco Aero-Flo RV Roof Vent Cover w/ Swing Open Lid # CAM40421 which measures 22-1/2" long x 20" wide x 9" high.

expert reply by: Jameson C

0

Answer 1

You can still the use the MaxxAir II RV and Trailer Roof Vent Cover w/ EZClip #MA86JR on your Fan-Tastic roof vent. This vent cover comes with brackets that will screw into the sides of your vent to give an attachment point for the cover.

view full answer...

Answer 2

The MaxxAir FanMate vent cover Item #MA00-955001 is going to be just a little taller but the louvred end tapers in and it does not come with the screen which is Item #MA00-955202. 25" long x 18-1/8" wide x 10-1/4" tall. The MaxxAir II…

view full answer...

Answer 3

For the replacement Vista Lippert Light you have you'd need the part #LC24PJ.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...