Air Helper Springs For A 2023 Hyundai Palisade

Question

Question:

I need air helper springs for my 2023 Hyundai Palisade

asked by: Gina

0

Expert Reply:

We have the perfect air helper springs that are confirmed to fit your 2023 Hyundai Palisade!

The Air Lift 1000 Air Helper Springs for Coil Springs # AL29PD provides a 1,000 pound capacity that will help to improve safety and ride quality. The bags are constructed of durable, molded polyurethane. The kit installs inside your vehicle's rear coil spring suspension, and have an adjustable air pressure between 5 psi to 35 psi.

I attached a review video link below.

expert reply by: Noah E

0

Answer 1

I may have a solution for you to add a suspension enhancement to the rear axle of your 2019 Kia Sorento, but there are not any Sumo Springs parts that will fit. However, you can use the Air Lift 1000 Air Helper Springs for Coil Springs - Rear…

view full answer...

Answer 2

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 3

The Air Lift kit part #AL29PD that you referenced is a confirmed fit for your 2019 Hyundai Santa Fe SE and would do a great job providing additional suspension support. This will get rid of the rear suspension sag you are experiencing when towing.…

view full answer...

Answer 4

Not all vehicles and hitches can be used with weight distribution systems since they do put an additional strain on the overall setup. So for your 2019 Kia Sorento you can use an air spring suspension enhancement kit like the Air Lift part #AL29PD to…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 8

Hey Tarek, for your 2023 Ford Raptor I recommend checking out the Timbren Suspension Enhancement System #T75MR. This suspension enhancement system has a load leveling capacity of 3,000 lbs, will increase stability while reducing sag, and will install…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

There's not many differences between the Air Lift WirelessONE item #AL25980EZ and item #AL25980. The main difference is that the item #AL25980EZ has a slightly higher CFM at 1.03 compared to 0.92 and it runs slightly more efficient at 9% over 15%…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...