Length Of Rubber Hollow Bulb Seal # CS45FR

Question

Question:

Good Morning, could you please tell me if the item - Rubber Hollow Bulb Seal for RV and Trailer Door - Stick On - 25foot Long x 9/16inch Tall Item # CS45FR - is a 1 length of 25 ft. or 2 pieces of 12.5 ft. I would need at least a 15 ft. length. Thank You

asked by: Ray

0

Expert Reply:

The Rubber Hollow Bulb Seal for RV and Trailer Door - Stick On # CS45FR is one piece and is 25 foot long. You can use scissors to trim the extra unwanted seal. The EPDM rubber won't shrink, crack, or fade over time.

expert reply by: Noah E

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

I definitely recommend replacing your 3,500 lb 26 inch leaf springs with the 26 inch 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles #e22YR. The 4,500 lb would be too stiff and your ride would suffer so the better option by far are the 4k…

view full answer...

Answer 5

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 6

The correct replacements we offer for the Glo Brite Marker Lights 118A and 117R is the Trailer Clearance or Side Marker Light part #MC44AB for amber and part #MC44RB for red.

view full answer...

Answer 7

Trailer spindles are welded directly to the axle so to remove one it just needs to be cut off completely using a torch or saw. Then to replace the spindle such as with the EZ Lube #TRU37FR that you were looking at it's extremely important that it…

view full answer...

Answer 8

If you are needing to completely remove the spindles on your trailer and replace them with new ones the old ones just need to be cut off. These are welded directly to the axle so you will need to use a torch or saw for this process. When installing…

view full answer...

Answer 9

The Solera 12V Power RV Awning Conversion Kit #LC434723 that you referenced is compatible with your Dometic awning and will easily convert it to a power awning so that you don't have to struggle to deploy it. This will simply require changing the…

view full answer...

Answer 10

There isn't a grease fitting on the Lock n Roll setups like the part #336VS501 that you referenced. Greasing it would require manual application in the moving parts. The LMX grease like the part #L11390 is the toughest and most waterproof so that…

view full answer...

Length Of Rubber Hollow Bulb Seal # CS45FR

Product Page this Question was Asked From

Continue Researching