Recommended Buyers Truck Mud Flaps for 24 Wide x 40 Tall Application

Question

Question:

I need 24 x 26 inch Rubber Mud Flaps - if I cut the lower portion of 337B40LP up to the thickened horizontal band/section what would be the resultant height ?

asked by: Gerry G

0

Expert Reply:

Cutting the Truck Mud Flaps 24" Wide x 40" Tall # 337B40LP at that first horizontal band/section will give you a height of about 22" - 24". To save on how much extra material you'll have I recommend going with the Truck Mud Flaps 24" Wide x 30" # 337B30LP instead so you're just clipping off 4" from the bottom.

Depending on your setup you may need the 90-Degree Mounting Plates # 337MFBH2375A to finish your installation. Buyers also has the Bolt Hole Reinforcement Plates # 337MFW2375 to help make the connections more stable.

Attached are some videos for you to check out.

expert reply by: Jon G

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

According to Buyers Products, their #3371809067 is indeed a fit for a 2021 Ram 3500 Chassis/Cab with a 10K GVWR. The hitch has a maximum gross trailer weight capacity of 20K. If you click the provided link, you can see a product description video…

view full answer...

Answer 3

I confirmed with Buyer's Products that the Truck Mud Flaps #337RC40PPB are made of TirePlast T70. I went ahead and attached the MSDS sheet to show the different properties, fluid resistance, and other specs they have available.

view full answer...

Answer 4

The Buyers Products Hitch Plate #3371809067 manufacturer specs are, Width of the hitch plate is 34-1/16" Length of the hitch plate is 15-1/4" Thickness of the horizontal bumper is 2-3/8"

view full answer...

Answer 5

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

view full answer...

Answer 6

Installing the P3 on your 2013 Volkswagen Touareg is possible, however an aftermarket plug-in harness is not available. If the pigtail that you found under your dash is for a brake controller, you will either have to splice the wires from the brake…

view full answer...

Answer 7

It depends on which Bulldog powered A-frame trailer jack you have. For example, #BD500200. has a cap on top and you can use a socket wrench and socket to manually crank the jack up and down. Jacks #BD500187 and #BD500188 come with a handle. But both…

view full answer...

Recommended Buyers Truck Mud Flaps for 24 Wide x 40 Tall Application

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching