How to Manual Raise and Lower a Bulldog Powered A-Frame Trailer Jack  

I spoke with my contact at Bulldog, and he provided several possible causes for the problem you are experiencing. The jack grounds via its attachment point to the trailer. In case there is excessive paint between the jack and the trailer frame,…

What he will need to do is to use an appropriate sized socket and wrench on the end of the rod located above the electric motor on Bulldog Powered-Drive Kit for Single-Speed Jacks, #BD1824200100. He will also most likely need an extension in order…

I spoke with my contact at Bulldog and he said they do not offer replacement parts to rebuild the gear box for the Bulldog Powered-Drive Trailer Jack, #BD500200. Typically the gears get damaged due to over extension or retraction. Before installing…

The distance from the top of the mounting plate to the bottom of the housing on the Bulldog Powered-Drive Trailer Jack, #BD500200, is 13 inches.

The Bulldog Powered-Drive Trailer Jack, item #BD500200, only has one wire, the power wire. This jack attaches to ground through the mounting hardware and the trailer frame. When wiring the jack to your 7-Way trailer connector you will need to make…

I checked out the instructions on a Bulldog Electric Jack, part #BD500188, we offer and in the maintenance section, they say that the jack is sealed and maintenance free. The instructions say to periodically check the mounting hardware for proper…

Sounds like the 12 volt accessory circuit of the 7-way of your 2000 Chevy Silverado is not active so the Bulldog Jack part #BD500200 that you referenced is not getting power. There are a few connections under the hood of your truck that need to be…

I have a solution for you, but the Bulldog #BD500200 is only going to be about 2" shorter than you current jack, and I think we can do a little bit better than that to make sure that you get full use of the tailgate on your 2019 Chevy…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

With the weight of your camper I recommend the Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL35FJ. I prefer these as they have the internal jounce bumper which helps to reduce the bounce that is often associated with towing a trailer and…

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…