Matching Rear Cover for Regal Solera Idler Cover part # LC88VR

Question

Question:

What is the # for the rear back cover for a LC88VR white awning idler cover

asked by: Ken C

0

Expert Reply:

The correct matching back cover for the Regal Solera Idler Cover part # LC88VR that you referenced is the part # LC25KR.

expert reply by: Jameson C

0

Answer 1

The Kodiak Disc Brakes #KOD33FR are the brakes you will need to convert your 7,000lb axles to use disc brakes. This kit provides the brake assemblies for one axle so you will need 2 kits for your 5th wheel. It fits a standard #42 spindle with a…

view full answer...

Answer 2

I can certainly help you out with a disc brake set up on your trailer. The first thing we need to find out in order to select the correct parts would be the inner and outer bearing numbers stamped into the sides of the bearings in the hubs you have…

view full answer...

Answer 3

As long as you have the Regal style cover on the idler head, the #LC88VR would be the correct replacement for a white cover or #LC643923 for a black cover. If you have the standard or plain type cover which has an offset shape and the LCI logo in a…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 6

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 7

The "KTC 7600" stamped on the brake pad doesn't look to be a part number, so I can't cross reference it, but we do know you have Kodiak ceramic brake pads. So to determine the correct brake pads, all you need to do is match up…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 10

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...