Replacement Awning Fabric for V000223163

Question

Question:

Need awning fabric only. 5852985165

asked by: Anthony T

0

Expert Reply:

Thanks for the picture of the label on our Lippert awning based on that what you have is the part # LCV0002231 and for replacement fabric you'd need the part # LCV000334398.

expert reply by: Jameson C

0

Solera
(click to enlarge)

Answer 1

The Solera 16' Replacement Awning Fabric - Black Fade #LCV000334394 does have that short black section towards the coach side that will wrap around and offer a little more protection to the awning from the elements. As long as your Solera awning…

view full answer...

Answer 2

I've attached an exploded diagram photo of the vent assembly that uses the Replacement Operator Mechanism for MaxxAir MaxxFan Plus or MaxxFan Deluxe Roof Vents #MA10-20281K-1AF for you to check out. You'll need to use it as a guide for…

view full answer...

Answer 3

We have the following Solera 16 foot replacement awning roller and fabrics: Solid Black #LCV000211487 Black Fade #LCV000211486 White Fade #LCV000211492 Sand Fade #LCV000223189 Sand Fade with Weather Guard #LCV000223163 All are direct replacements for…

view full answer...

Answer 4

Hello! Since you measured your roller bar and fabric to be 16' wide, you are correct that the 16' Solera 16' #LCV000223163 is the correct replacement roller bar and fabric.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...