Do I Need An Anti-Flicker Harness To Use The H11 LED Headlight Bulbs On A 2016 Volkswagen Jetta

Question

Question:

Will the ARC89FR be an adequate replacement for the OEM fog lights? Will I need any other equipment for install?

asked by: Vince

1

Helpful Expert Reply:

The H11 LED Headlight Bulbs - Single Beam - 1,995 Lumens - Cool White - Qty 2, part # ARC89FR, will need the Anti-Flicker Harness for ARC H11 LED Bulbs - Qty 2, part # ARC66FR, if you have CANbus or PWM equipped vehicles. I did some online research and you will need the flicker harness for your 2016 Volkswagen Jetta.

I have included a product description link and video review links below.

expert reply by: Mark Smith

1

Answer 1

You can certainly replace your 2013 Subaru Outback's factory hitch with a larger 2 inch hitch like the Draw-Tite #75673 so long as your Outback is not a Sport model. I reached out to the manufacturer to try and find out if the Draw-Tite would…

view full answer...

Answer 2

I took a look at the online owner's manual for your 2012 Subaru Outback and found that as long as you have the 3.6L engine, the vehicle is capable of towing a 3,000 pound trailer if it is equipped with brakes. For a trailer without brakes, the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...