Replacement Slide Out Motor for a Power Gear 1010000188 Slide Out Motor

Question

Question:

Is there a replacement for power gear slide motor number 1010000188 for 2008 National Sea Breeze?

asked by: Mike M

0

Expert Reply:

Yes, the Replacement Gear Motor Assembly for Lippert Slide-Out # LC368446 is the correct slide out motor for your Power Gear 1010000188.

The Replacement Gear Motor Assembly for Lippert Slide-Out # LC368446 is the 1010000188 motor.

expert reply by: Scott S

0

Answer 1

To replace your defective Power Gear 130-1305 RV Slide-Out motor, you'd use the LCI #LC368446. I have attached a link below.

view full answer...

Answer 2

I spoke with my contact at Lippert who said that there is a replacement option for your slide out motor, but unfortunately there aren't any motors that have higher torque ratings available. The replacement 368446 motor you referenced is part…

view full answer...

Answer 3

The tankless water heaters we offer require wiring to be connected and do not have the telephone style cable you are referring to however; the wiring portion and instillation is very straight forward. I recommend checking out the Fogatti RV Tankless…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 10

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 11

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Replacement Slide Out Motor for a Power Gear 1010000188 Slide Out Motor

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching