Jif Marine Gunwale Hook Ladder DMT3A-11 Hook Depth  

The long brackets of the Removable Extreme Off-Road Swing-Up Trailer Jack #ARK57FR that mount on inside of trailer frame are little misleading since they are much taller than the bracket on the other side of the jack that it attaches to. Basically…

With trailer tires like #AM30670 you have to run the max tire pressure rating that's on the sidewall of the trailer. This ensures you get the full weight capacity of the tire and also that you prevent any heat build up which also leads to…

I did some calculations and came up with a 6.78 inch tall sidewall on your tire that combined with the 9 inch Radius of your wheel would give you 15.78 inches above and below the center of the wheel mount location on the Curt Hitch Mounted Spare Tire…

If you are using the Aluminum Lynx Trailer Wheel part #LHSL311 then your trailer will have 1/2-20" lug studs therefore, in order to secure your spare wheel/tire to the Curt Trailer Hitch Mounted Spare Tire Carrier part #C31006 I recommend using…

The interesting thing about trailer tires is that they need to be inflated to their max psi rating at all times regardless of load. This ensures that heat does not build up which causes premature failure. So for a tire like the Loadstar 4.80-12 Bias…

The Jif Marine Telescoping Gunwale Hook Ladder #JIF28FR measures 38" from the apex of the hook to the bottom step. The spacing between each rung is 11.5". That would make the measurement to the stand-offs from the apex of the hook…

You can still install the tie-downs, but since the installation hardware used for the BoatBuckle G2 Tie-Downs #IMF14220 is 3/8 inch in diameter, the 1 inch transom strap holes on your trailer will be too large to install these tie-downs. The best…

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

Unfortunately we do not have a video of the HappiJac Truck-Mounted Camper Tie-Downs #LC184089 being installed. The Rear anchors are installed in the end of the bumper. There is no precise mounting location since a variety of bumpers may be installed.…

You are a little on the warm side for your transmission fluid. If you can keep it under 200 degrees you will have the max life out of it. That being said transmissions really start to go downhill at 260 degrees. The Derale cooler part #D13503 with…

The best hitch I'd recommend for your 2011 Chevy Silverado is the Curt hitch part #14301 because it has great towing capacities at 10,000 lb trailer weight and because it has only the hitch tube that hangs below the rear bumper for a more…