Replacement Fenders for 2002 Escort Trailer

Question

Question:

I need to order replacement fenders on my 2002 Escort trailer. The tires are 14 inch. Will these fenders fit my trailer? Should the mounting holes align? My fenders have lights. Will I need to punch out openings for the lights?

asked by: Reba K

0

Expert Reply:

The Fulton Single Axle Trailer Fenders with Top and Side Steps # F008574-2 is designed to fit trailers with 14" wheels. This means you should not have a problem using the fenders with your trailer. These are designed to use the existing hardware or brackets you already have for your existing fenders for installation. If you are unable to use the existing mounting method, fabrication of mounting brackets may be required.

I recommend measuring your current mounting brackets to see if they align with the mounting slots on the fenders. The mounting slots are 30-1/4" apart and 4-1/8" wide. The overall dimensions of the fenders are 9-5/8" wide x 42-5/8" long x 12-3/4" tall. Also, you will need to cut out the holes for your lights. I have attached a picture where another customer used these fenders and added lights below.

expert reply by: Robin H

0

F008574-2 Fenders With Lights Added On Customer Trailer
(click to enlarge)

2002 Escort Trailer Fender.
(click to enlarge)

Answer 1

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 2

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 3

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 4

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 5

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 6

Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…

view full answer...

Answer 7

A 16 inch tire will not fit on a 16.5 inch wheel. You would either need to get new 16 inch wheels with the proper bolt pattern to match what the hubs require or to get your existing wheels you would need to go with 16.5 inch tires. You mentioned you…

view full answer...

Answer 8

The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you some…

view full answer...

Answer 9

The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the bolt…

view full answer...

Answer 10

It's totally normal for a bit of movement between any fifth wheel hitch and the base rails. The feet on the hitch are typically a bit smaller than the slots they slide into for mounting otherwise you'd have a hard time getting your hitch in…

view full answer...

Answer 11

The B&W Companion OEM 5th Wheel Trailer Hitch #BWRVK3700 is perfectly compatible with cushioned pin boxes like your MORryde RP072-1621HD, so the clunking you're experiencing isn't related to the two components being incompatible. With…

view full answer...

Answer 12

It looks like all 2015 Honda Pilots come equipped with a hitch already (save for a select few). It's for that reason that none of our manufacturers made hitches for it, and why the 2016 hitches will not fit. In the middle of your back bumper, you…

view full answer...

Replacement Fenders for 2002 Escort Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching