Frame Mounted Camper Tie Downs for 2005 Chevy Silverado 3500

Question

Question:

Would like a frame mount front kit to fit 2005 Silverado 3500

asked by: John H

0

Expert Reply:

The correct frame mounted tie downs you'd need for your 2005 Chevy Silverado 3500 with running boards and a factory hitch is the Torklift Tie Downs part number # TLC4203 and # TLC3206 for the front and rear.

expert reply by: Jameson C

0

Answer 1

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 2

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 3

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The correct tie-downs for your 2019 Ram 3500 Tradesman short bed depend on your hitch. You can choose from the following: With a factory installed hitch or non-Torklift aftermarket hitch -TorkLift Talon Camper Tie-Downs #TL52XR (front) and #TL34FR…

view full answer...

Answer 6

I really like the Curt Trailer Hitch Receiver #C14108 for your 2005 Chevy Silverado 2500HD Short Bed because it has a hidden crosstube and is a Class IV rating so it's nice and sturdy for up to 10K trailers or 12K trailers if a weight…

view full answer...

Answer 7

You do not need to remove the bed of your truck to install the HappiJac part #LC182906-182971 that you referenced. I found a copy of the install instructions for this part number (see attached pictures) and there's no mention of the bed needing…

view full answer...

Answer 8

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Frame Mounted Camper Tie Downs for 2005 Chevy Silverado 3500

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching