Does Sealed Mini Rectangular Trailer License Plate Utility Light Include Connection Hardware

Question

Question:

What type of wire connector is on this light?

asked by: Brad

0

Expert Reply:

The Sealed, Mini Rectangular Trailer License Plate, Utility Light with Stainless Steel Base, item # UL94CB, does not include any connection hardware, such as a quick splice or butt connector. You will need to connect the wire on the back of this light to a running light wire on your vehicle, and the light should illuminate your license plate whenever you are driving your vehicle.

expert reply by: Andi

0

Answer 1

Yes, we do carry a version of the #MCL95AB with a clear lens. For that you would want the part #UL94CB.

view full answer...

Answer 2

The Optronics license plate light #UL94CB is sealed so you cannot change the bulb. The bulb that is used is a long-lasting heavy duty bulb but you cannot access it. We do have other license plate lights that might work for you. I have linked the…

view full answer...

Answer 3

For a license plate light and bracket on your boat trailer you want to use one that is submersible like the Optronics LED Trailer License Plate Light with Bracket - Submersible - 5 Diodes - Clear Lens #LPL56CB. I would not use the #M290B-P on your…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Does Sealed Mini Rectangular Trailer License Plate Utility Light Include Connection Hardware

Product Page this Question was Asked From

Continue Researching