Difference Between Lippert LC32NJ and LC289560 Drive Head Covers

Question

Question:

the lippert awning drive head cover. what is the difference between the lc32nj cover and the lc289560? I have a geo pro 20fbs

asked by: Robert G

0

Expert Reply:

The Lippert # LC289560 and # LC32NJ are designed for two different awnings. The # LC32NJ fits all Lippert Edge awnings while the # LC289560 fits all Solera plain power and manual head assemblies.

expert reply by: Robin H

0

Answer 1

Since you need the cover for the drive head of a Lippert Edge awning the correct replacement is the part #LC32NJ.

view full answer...

Answer 2

For the Replacement Cover for Solera Awnings #LC643923 for the idler head, and the Replacement Cover for Solera Awnings #LC643922 for the drive head, you can use the: -Replacement Solera Manual Awning Head Cover Fastener #LC266156, which are #6 x…

view full answer...

Answer 3

In order to separate two awning head covers such as the Solera Awning Plain Drive Head Front Cover part #LC289560 and the Solera Awning Plain Drive Head Back Cover part #LC289561 you'll need to remove the screws which are accessed from the back…

view full answer...

Answer 4

A lube plate will be more specific to the fifth-wheel hitch in your truck than to the particular pin box model that is on your new trailer. You will just want to make sure the lube plate you purchase provides enough surface area to cover your Reese…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...