Troubleshooting TST Wireless Tire Pressure and Temperature Monitoring System

Question

Question:

We have a LUXE 44FL with the TST 507/with booster. While in motion we continually loose signal from 1 to 3 of the tires. This has been random from left to right and axle 1 2 or 3. Any ideas?

asked by: Jason A

0

Expert Reply:

For the TST TPMS for RVs, # TST-507-FT-6-C ensure the battery is reading over 3 volts, replace with a new battery if low voltage. If the battery for all sensors are of sufficient power, try recoding the sensor. This is displayed on page 7 of the Wireless Tire Pressure and Temperature Monitoring System Instruction Manual. I have linked a copy below.

expert reply by: Michael R

0

Answer 1

It sounds like you're looking for a weight distribution shank with more drop to level the trailer and if that's the case we may have an option for you. In order to see how much you need, measure from the ground to the top inside edge of the…

view full answer...

Answer 2

I would not recommend using your current Husky Center Line as it is way to heavy for your new Airstream Flying Cloud FB23. With a weight and sway hitch you really want to ensure that your tongue weight will match your trailer. Without enough weight…

view full answer...

Answer 3

When the instruction manual for the Curt TruTrack Weight Distribution System part #C17499 states to set the bracket height closest to the spring bar position set with the jack earlier, they are referring to the when you raised the front of the…

view full answer...

Answer 4

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 5

I am sorry but we do not have an AC cover with those dimensions. The closest option we have is the Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners item #AT3308046006 which measures 40-1/2" long x 29" wide x…

view full answer...

Answer 6

The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…

view full answer...

Answer 7

Yes, you can use the NOCO GEN On-Board Battery Charger #NOC34FR on your pickup's parallel batteries without disconnecting them. If your batteries were in a series, they would have to be disconnected. Since your batteries are parallel and maintain…

view full answer...

Answer 8

In order to charge your batteries wired in parallel with the NoCo Genius #329-GENIUS5 you'll want to connect the positive charge line to the positive terminal of the first battery and the negative line to the negative terminal of the opposite…

view full answer...