Replacement L-Pin for Fastway e2 Weight Distribution System

Question

Question:

5/8 inch square pin for e2 hitch

asked by: Dale M

0

Expert Reply:

It sounds like you're looking for the Replacement L-Pin for Fastway e2 Weight Distribution Systems # FA92-03-9205 which is for the larger e2 weight distribution systems. If you also need the clip you can find that as part # FA92-04-9208.

expert reply by: Jon G

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

It sounds like you're looking for the spring bar retention bracket for your Reese Pro Round Bar Weight Distribution #RE94FR. The correct replacement is the Replacement Spring Bar Retention Bracket Kit #RP58498.

view full answer...

Answer 5

Good question, and what happens is that leaf springs elongate over time, and since you mentioned you got measurements of 25-1/2 inches from center eye to center eye and 26 inches under partial load, the best option for leaf springs really is the…

view full answer...

Answer 6

To swap out the 800 lb tongue weight spring bars of your E2 system to 1,000 lb spring bars you would want the part #FA92-01-1099.

view full answer...

Answer 7

The 'sleeve' or shank portion of the Fulton #F500266 caster assembly is meant to be compatible with Fulton F2 trailer jacks, which is why it's kind of oddly shaped. At the widest point, that sleeve is 2-1/2 inches in diameter, as shown in…

view full answer...

Answer 8

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 9

We definitely have some trailer jacks you can use as a replacement for your Dutton-Lainson but it doesn't look like anything we have will work as a direct replacement. If you'd like to stick with the Dutton-Lainson brand then I recommend…

view full answer...

Answer 10

The reason why you would need the #VGR74VR filter to use the #ASA37YR is because your 2022 GMC Sierra 1500 will have pulse width modulation (PWM). This means it won't send consistent power back to the camera and you're going to lose the…

view full answer...