What is the Bolt Hole Mounting Pattern for Dutton Lainson Trailer Hand Winch # DL14725

Question

Question:

Can you tell me the minimum distance between the mounting holes on this winch. DL 14725 My trailer mounting holes are three inches apart.

asked by: Bob J

0

Expert Reply:

I will be happy to show you the mounting hole dimensions for hand winch # DL14725. I have included a picture that shows them for you. This winch can be used with either a strap, # DL24249, or a cable # DL24104. Straps are much better for marine applications because they will not rust.

The strap is rated for 4,000 pounds and the cable is rated for 3,500 pounds. You always want the cable or strap capacity to be at least 1.5 times greater than the winch capacity or higher for safety.

expert reply by: Michael H

0

click to enlarge

Answer 1

If the gear is broken on your existing Shelby winch, I recommend simply replacing the entire unit, as Shelby is no longer in business and replacement parts are not readily available. To replace your Shelby 5408 model, I recommend the Dutton-Lainson…

view full answer...

Answer 2

The 17.3:1 ratio is normally used when you have a heavier load or boat you want to winch in. Sort of like the gears on a bike. When going up a hill you put the bike in a highwer gear so it is easier to reach the top. when on a flat surface you drop…

view full answer...

Answer 3

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 4

The size winch that you will need depends on a couple of different factors. I have included part of our hand winch FAQ below regarding boat winches and have linked the FAQ article for you to view. Finding the Right Capacity Winch for your Boat…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The 2-Speed Boat Trailer Winch part #315-W3200D is an excellent upgraded 3,200 lb winch for a boat trailer. In regards to mounting, not all winches use the same pattern so you'd need to compare the dimensions in the photo below to what you have…

view full answer...

What is the Bolt Hole Mounting Pattern for Dutton Lainson Trailer Hand Winch # DL14725

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching