Distance Between the Center of the Jack-Adapter to the Center of the Handle Knob

Question

Question:

Hi, how long is the arm of handle GCSQTW-30008-HD from center of jack-adapter to center of handle knob?

asked by: Gunnar E

0

Expert Reply:

The Replacement Topwind Red Knob Handle for etrailer Gooseneck Coupler # GCSQTW-30008-HD has a measurement of 10.5" from the center of the jack-adapter to the center of the handle knob.

expert reply by: Scott S

0

Measurment Between Jack-Adapter and Knob Handle on etrailer Topwind Red Knob Handle
(click to enlarge)

Answer 1

I reached out to the company that builds the Ram Gooseneck Coupler item #GCSQTW-30008 , Pacific Rim International Factory, and was not able to get an exploded parts diagram. I have listed all of the replacement parts below that are available.…

view full answer...

Answer 2

If the coupler will not adjust be sure that the set screw (shown in the linked photo) has been loosened to allow the coupler to move. If the set screw has been loosened and the unit will not adjust try applying a product like PB Blaster or WD40 to…

view full answer...

Answer 3

I checked with my contact at Ventline and for your PR-8 100-CFM range hood the correct replacement motor is the part #BVD0278-00. Then for the fan blade you will need part #BCD0409-00.

view full answer...

Answer 4

Absolutely! The HD84546BX you mentioned is a 10"x2-1/4" hub and drum assembly with a 5 on 4.5" bolt pattern for a 3500lb axle. This hub uses inner bearing #L68149, outer bearing #L44649, and grease seal #RG06-050. While we do not have…

view full answer...

Answer 5

I reviewed quite a few photos of various Charmac cargo trailers and while I found some with external fenders I did not find any shown with lights installed. However, we do offer a lot of combination red/amber trailer lights and all are shown on the…

view full answer...

Answer 6

From what I was able to find out from my research, the Tie Down Engineering 11033 hub has a 5 on 4-1/2" bolt pattern and is designed for 3500-lb axles. Replacement hubs that have these specs typically use a #L68149 inner bearing and #L44649…

view full answer...

Answer 7

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

view full answer...

Distance Between the Center of the Jack-Adapter to the Center of the Handle Knob

Product Page this Question was Asked From

Continue Researching