Replacement Motor and Fan Blade for Ventline PR-8 100-CFM Range Hood

Question:

What is the correct motor and fan replacement for a Model PR-8 100 cfm, 120 v, 60 Hz, 1.8 amp 1.5 amp mtr

asked by: Angela R

Expert Reply:

I checked with my contact at Ventline and for your PR-8 100-CFM range hood the correct replacement motor is the part # BVD0278-00. Then for the fan blade you will need part # BCD0409-00.

expert reply by: Chris R

click to enlarge

Craig

4/7/2024

Whats the difference between HG-8 and the PL-8 which is what I have the box and tg you have in the pic is the same that I have except PH not Pl thanks

William N.

11/16/2021

I installed the motor and fan into the hood, but it blows not suck. Since the is only a high speed and low speed wire and the motor spins CCW, I will need another fan blade. Do you have any info on a fan blade?

Les D.

11/23/2021

@WilliamN I contacted the manufacturer and they suggest that the fan blades are backwards on the motor shaft. Switch that around and let me know how it works.

Sherry

5/10/2020

I am looking for the whole silver box for model number PR-8 100-CFM

Chris R.

5/12/2020

I'm not sure if it's what you're looking for, but the closest option to this that we have available is the Wiring Cover # CA0461-02, which will fit your PR-8 Range Hood model. We don't have the whole outer frame/box available by itself.

Kim S.

9/2/2020

I was in search of the same part and I think it is called the Blower housing. In a document you have on the PR-8 regarding replacement filters there is a diagram with Blower housing labeled but there is not a part # listed. It says you must contact the factory. Am I reading that correctly? Is it possible to get the blower housing? Is there a recommended vent hood that replaces the Ventline PR-8 if the blower housing is not available?

Jon G.

9/4/2020

@KimS If the document mentions reaching out to Ventline for a replacement blower then I'd try going that route. The are pretty good about having replacement parts for their vents.