Recommended Bearing Kit For Dexter Trailer Axle # T20BTR-7258

Question

Question:

What is the oil seal ID for this axle. My current hubs have a 1.5inch ID seal. If this axle doesnt use a 1.5inch ID seal, what seals would be needed?

asked by: Douglas M

0

Expert Reply:

With The Dexter Trailer Axle Beam with Standard Spindles - 72 inch Long - 2,000 pounds # T20BTR-7258 the correct bearing kit you would need is The Bearing Kit, L44649 Inner/Outer Bearings, 10-60 Seal # BK1-150. The grease seals ID is 1.500.

I attached a review video link below.

expert reply by: Noah E

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The 3 inch shackle bolt part #166081 would be a great option to use with the CE Smith suspension hanger part #CE14016G. This would be a better fitting size than going with the longer 3.5 inch bolt you mentioned.

view full answer...

Answer 4

We have one double-eye leaf spring that has a 7,000 lb axle rating. For that you would want the part #e64SR. The hanger kit you would need then to go with that is the Dexter Heavy Duty kit part #K71-360-00. The axle spacing will be 33 inches which is…

view full answer...

Answer 5

If a spindle is bent you cannot bend it back in place. Replacing the axle would be the best route. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference.…

view full answer...

Answer 6

The correct replacement for your Klauber K01431B300 slide-out motor is the Replacement Motor Assembly for Lippert RV Slide-Outs - Klauber A-300 Model #LC157511.

view full answer...

Answer 7

Assuming your tires are in good shape without any bulges the easiest way to determine if you have a bent spindle is to take a straight edge that is longer than the tire and lay it across the tire parallel with your trailer frame and then measure the…

view full answer...

Answer 8

That is not normal. The Hayes Syncronizer Trailer Brake Controller - 1 to 2 Axles - Time Delayed #HA81725 should not give off any smell and should not be activating the brakes enough to cause smell if installed and adjusted properly. I've…

view full answer...

Answer 9

The Pop & Lock Custom Tailgate Handle #PAL85510 is the correct fit for your 2015 Toyota Tacoma. Since you have a camera you'll want to also pick up the Camera Mounting Clip for Pop & Lock Custom Locking Tailgate Handle #PL5455CAMB and can…

view full answer...