Is Andersen Trailer Hitch Lock and Adjustment Pin Lock Set Keyed Alike

Question

Question:

Can I buy 2 of these hitch pins that are keyed alike

asked by: Jeff T

0

Expert Reply:

The 2 pins that come with the Andersen Trailer Hitch Lock and Adjustment Pin Lock Set # AM3493 are keyed alike but if you're wanting to get 2 sets of these there unfortunately isn't a way to get them keyed alike so you'll have 1 key per EZ Hitch or EZ HD ball mount.

expert reply by: Jon G

0

Answer 1

Hey Pete, so the part #DM16680-52 has a much higher capacity at 21k whereas the part #DM14793-81 has a 10k capacity.

view full answer...

Answer 2

Generally the Demco A-Frame Trailer Coupler w/ Jack Hole part #DM14793-81 is very easy to release. There is a lock/pin hole located just under the latch that may have a pin in it preventing it from opening. I have linked a photo showing exactly where…

view full answer...

Answer 3

The coupler you referenced does not have replacement parts or a latch repair kit so if the thumb latch is busted you will need to replace the unit with the A-Frame Coupler #CA5400. You can replace it with the same unit, the A-Frame Coupler #CA5400…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 6

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 7

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 8

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 9

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 12

That is an excellent question and is asked more often than you think. Electric brakes like what come in the Electric Trailer Brake Kit #AKEBRK-2 can be submerged in water when you are loading/unloading your boat. Since water and electricity don't…

view full answer...